User& Setupinstructions - Maytag MAH22PNAGW0 Installation Instructions Manual

USER& SETUPINSTRUCTIONS
PERM. WOOLENS DELICATES
1. Door must be closed before cycle selection is made.
2. Press fabric setting keypad for the wash cycle desired. After
the cycle is started, the time will display and count down.
.... INOPERATIVE STATE - These lines on the display indicate
the washer is inoperative. Enter setup mode to view diagnostic
code.
"0 MINUTES" SHOWING IN DISPLAY - This condition indicates
the washer cannot be operated. Coins dropped during this
condition will be stored in escrow but cannot be used until
normal operation is restored by opening and closing the door. If a
door switch fails, it must be replaced before normal operation
can be restored.
COLD START (Initial first use) - Washer is programmed at the
factory as follows:
Washer 14-minute wash period
3 rinses (extra rinse not enabled)
7 x coin 1 wash price
WARM START (after power failure) - A few seconds after power
is restored, if a cycle was in progress at the time of the power
failure, "RESELECT CYCLE" will flash in the display, indicating
the need for a key press to restart washer.
DOOR LOCK - Prior to beginning a cycle, there is a door lock
routine of IocWunlock then cycle begins. The door will remain
locked until the end of a cycle or approximately 2 minutes after a
power interruption.
PRICING - After the door is opened following the completion
of a cycle, the display indicates the cycle price (unless set for
free operation). As coins are dropped, the display will change
to lead the user through the initiation of a cycle.
FREE CYCLES - This is established by setting the cycle price to
zero. When this happens, "SELECT CYCLE" will appear rather
than a cycle price.
DISPLAY - After the washer has been installed and plugged in,
the display will show "0 MINUTES." Once the washer has been
plugged in and the washer door opened and closed, the display
will show the price. In washers set for free cycles, the display will
flash "SELECT CYCLE."
IMPORTANT: Read all instructions before operating.
PD Models: Insert service door key, turn, and lift to remove
access door.
Electric Shock Hazard
Plug into an earthed socket outlet.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electric shock.
Plug in washer or reconnect power. The washer is now in the
setup mode.
The lower fabric setting keypads and the digital display are used
to set up the controls.
The display can contain 4 numbers and/or letters and a decimal
point. These are used to indicate the setup codes and related
code values available for use in programming the washer.
HOW TO USE THE KEYPADS TO PROGRAM THE
CONTROLS
1. The PERMANENT PRESS keypad is used to adjust the
values associated with setup codes. Pressing the keypad
will change the value by increments. Rapid adjustment
is possible by holding the keypad down.
2. The WOOLENS keypad will advance you through the setup
codes. Pressing the keypad will advance you to the next
available setup code. Holding the keypad down will
automatically advance through the setup codes at a rate
of 1 per second.
3. The DELICATES & KNITS keypad is used to select or deselect
options.