Start Operating Setup; Washer Diagnostic Mode; Cleaning Your Washer - Maytag MAH22PNAGW0 Installation Instructions Manual

To enter the "Washer Diagnostic Mode," first enter "Start
Operating Setup." Then press and hold the DELICATES & KNITS
key for 1 second while in any of the setup codes one through six,
anytime a diagnostic code is present, or while dAS displays if
operating with Maytag Data Acquisition setup.
On entry to diagnostic mode the entire display will flash, a
cycle in process is canceled, money in escrow is cleared, and
diagnostic codes are cleared. If a diagnostic code persists,
it must be corrected before the following cycle options
are permitted.
There are five possible ways to initiate cycle activity from
diagnostic mode as follows:
1. Clean Washer cycle - With the entire display flashing, this
cycle is started by pressing the BRIGHTS keypad.
Use the Clean Washer cycle once a month to keep the inside
of your washer fresh and clean. This cycle uses a higher
water level. Use liquid chlorine bleach to thoroughly clean the
inside of your washing machine. This cycle should not be
interrupted. See "Cleaning Your Washer."
IMPORTANT: Do not place garments or other items in the
washer during the Clean Washer cycle. Use this cycle with
an empty wash drum.
2. Cycle Credit - With the entire display flashing, a cycle may be
credited by pressing the PERMANENT PRESS keypad (CC
will display). When the service mode is exited, "SELECT
CYCLE" will be displayed unless the end-of-cycle door
opening is required.
3. Manual Load Test Cycle - With the entire display flashing, this
cycle is started by pressing the WHITES keypad. This cycle
provides more typical full length fills, tumbles, drains, and
actuator dispenser movement, allowing for a more thorough
analysis of the washer operation, including pressure switch
behavior.
4. Quick Spin Cycle - With the entire display flashing, this cycle
is started by pressing the COLORS keypad. This cycle
provides a method to quickly drain and spin (remove water
from the washer) if desired.
5. History Overview Test Cycle - With the entire display flashing,
this cycle is started by pressing the WOOLENS keypad. This
cycle provides a quick verification that the cold and hot water
valves, dispensers, and pump motor are working and
actuator dispenser movement. It also includes drain and spin
operations.
Pressing the DELICATES & KNITS keypad will exit diagnostic
mode and cancel a diagnostic cycle in process.
DIAGNOSTIC CODES
If the setup mode is entered and one of the following has
occurred, the appropriate diagnostic code will be in the display.
d5 Blocked coin 1 or coin drop control circuit failure (coin
recognition and price display disabled while blockage
persists). PN Models Only: Setup mode J. should be
set to d (or Ed if in free operation mode) to eliminate
coin related diagnostic codes.
d9 Low voltage detected for 8 seconds.
d13 Blocked coin 2 or coin drop control circuit failure
(coin recognition and price display disabled while
blockage persists).
F20 Slow Fill. The washer will not detect water input for
4 min. Pressure switch failure or no water inlet. This
code is reported as d8 on d7.
F22 The door is not able to lock. Door lock error or
someone trying to start the washer, by pressing the
door switch with the finger. This code is reported as
d17 on Accu Trac.
(For different code consult service personnel)
WASHER HELP MODE
This mode is entered by pressing the PERMANENT PRESS
keypad while in special pricing option mode 2.XX (or while dAS
displays if operating with Maytag Data Acquisition setup).
In help mode, other display symbols and elements are mapped
to reflect the state of various inputs and outputs as follows:
Wash Water sensed at wash level
* Low voltage present
Circle above Door closed
digit
DOOR LOCKED Door sensed locked
COLD Cold water relay on
HOT Hot water relay on
OR Door unlock
AVAILABLE Drain pump ON
13