Installation Requirements - Maytag MAH22PNAGW0 Installation Instructions Manual

iMPORTANT SAFETY iNSTRUCTiONS
WARNING:
To reduce the risk of fire, electric shock, or injury to persons when using the washer, folow basic precautions,
including the folowing:
[] Under certain conditions, hydrogen gas may be
produced in a hot water system that has not been used
for 2 weeks or more. HYDROGEN GAS IS
EXPLOSIVE. If the hot water system has not been
used for such a period, before using the washing
machine, turn on all hot water faucets and let the water
flow from each for several minutes. This wil release
any accumulated hydrogen gas. As the gas is
flammable, do not smoke or use an open flame during
this time.
[] Before the washer is removed from service or discarded,
remove the door or lid.
[] Do not install or store the washer where it will be exposed to
the weather.
[] Do not repair or replace any part of the washer or attempt any
servicing unless specificaly recommended in this manual or in
published user=repair instructions that you understand and
have the skills to carry out.
[] See "Electrical Requirements" for earthing instructions.
SAVE THESE iNSTRUCTiONS
INSTALLATION REQUIREMENTS
Parts supplied for PD Models:
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
• Pliers (that open to • Flashlight (optional)
39.5 mm [1 9/16"])
Tools needed for installation
• Open end wrenches
1/2" and 9/16"
• Torx ®t T-20 Security
screwdriver
• 1¼.nut driver
• Level
• Wood block
• Ruler or measuring tape
Parts supplied
A B
E
D
• Service door lock cam
• Coin sensor white
• Coin sensor black
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here contact your authorized
Maytag distributor.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 2.4 m (96")
Overhead sewer Standard 76 L (20 gal. ), 762 mm (30") tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285834;
additional drain hose,
Part Number 8318155; and connector
kit, Part Number 285835
Drain hose 1.2 m (4 ft) drain hose extension kit,
too short Part Number 285863
Water taps beyond 2 longer water fill hoses:
reach of fill hoses 1.8 m (6 ft) Part Number 76314
3.0 m (10 ft) Part Number 350008
A. U-shaped hose form
B. Water inlet hoses (2)
C. Inlet hose washers (4)
D. Transit bolt hole plug (4)
E. Beaded tie strap
t® TORX is a registered trademark of Acument Intellectual Properties, LLC.