Secure The Drain Hose - Maytag MAH22PNAGW0 Installation Instructions Manual

1. Drape t hepower c ord over t hewasher top.
2. Move thewasher toitsfinal l ocation.
3. Place thedrain hose inthelaundry tuborstandpipe as
shown. See illustrations AandB.
4. Secure t hedrain hose using thesupplied b eaded tiestrap.
A B C
5. If the washer taps and the drain standpipe are recessed, put
the hooked end of the drain hose in the standpipe as shown.
See illustration C.
NOTES:
• Do not force excess drain hose back into the rear of the
washer.
• To avoid siphoning, do not seal the drain hose into the
standpipe.
Properly leveling your washer avoids excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
2. Make sure all four feet are stable and resting on the floor.
Then check that the washer is level (use a level).
3. After the washer is level, use a 9/_6"open-end wrench to turn
the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
4. The washer should not move front to back, side to side, or
diagonally when pushed on its top edges.
5. Slide the washer to its final location.
6. Confirm the levelness of the washer.
PD Model Washer is coin payment ready and allows the
connection of two different sizes of coins. Inside the drum is two
coin-sensor harnesses. To setup the washer for coin payment,
acquire a coin drop mechanism. Connect the white and black
coin sensors to the coin slot 1 and 2, respectively.
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended earthing
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water taps are on.
6. Check for leaks around taps and inlet hoses.
Electric Shock Hazard
Plug into an earthed socket outlet.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electric shock.
7.
8.
Plug into an earthed socket outlet.
To test and to clean your washer, measure _/2the detergent
manufacturer's recommended amount for a medium-size
load. Pour the detergent into the detergent dispenser. Select
any cycle and allow the washer to complete one whole cycle.
8