Tools And Parts; Options; Location Requirements; Drain System - Maytag MAH22PNAGW0 Installation Instructions Manual

Pedestal
You have the option of purchasing pedestals separately for this
washer. The pedestal will add to the total height of the washer.
Optional pedestal
Pedestal Approximate Color Model
Height height Number
with washer
(73 mm) 2 ds" (1207 mm) 47.5" White WHP040
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
basement, laundry room, or recessed area. See "Drain System."
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 60°C (140°F) water to the
washer.
An earthed electrical outlet located within 1.8 m (6 ft) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
• Hot and cold water taps located within 1.2 m (4 ft)
of the hot and cold water fill valves, and water pressure
of 137.9-689.6 kPa (20-100 psi).
• A level floor with a maximum slope of 25 mm (1 ") under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
• A sturdy and solid floor to support the washer with a total
weight (water and load) of 180 kg (400 Ibs).
Do not operate your washer in temperatures below 0°C (32°F).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
• The location must be large enough to allow the washer door
to be fully opened.
• Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90 °
and it is not reversible.
• Additional clearances might be required for wall, door, and
floor moldings.
• Additional spacing of 25 mm (1") on all sides of the washer
is recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
• When installed, the mains plug should be accessible for
washer disconnection from the mains supply.
Washer Dimensions
686 mm
1282 (27")
134 mm
(445/s '')
/
/
732mm
(2813/16")
Door is not reversible.
A floor drain should be provided under the bulkhead.
Prefabricated bulkheads with electrical outlets, water
inlet lines, and drain facilities should be used only where
local codes permit.
The washer can be installed using the standpipe drain system
(floor or wall), the laundry tub drain system, or the floor drain
system. Select the drain hose installation method you need.
See "Tools and Parts."
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
4