Connecting The Cables - Kyocera FS-1018MFP Basic Operation Manual

Preparation

Connecting the Cables

Connecting the Network Cable
Connecting the Parallel or USB Cable
3-8
The machine can be connected to a network or directly to a single
computer. This section describes the procedures to make both types of
connection.
To connect the machine to a network, use a network cable (10Base-T or
100Base-TX).
1 Press the Power Switch located
on the rear side of the machine to
Off ( ), and remove the power
cord from the outlet.
2
Connect the network cable to the
Network Interface Connector on
the rear side of the machine.
3 Connect the other end of the network cable to your network device (hub).
4
Program the required network settings. Refer to Network Settings on
page 3-11.
To connect the machine directly to your computer, use a parallel cable or
a USB cable.
IMPORTANT: Always power off the machine (
cord from the outlet before connecting the printer cable.
) and remove the power
BASIC OPERATION GUIDE