Kyocera FS-1018MFP Basic Operation Manual page 112

Troubleshooting
Message
Paper jam at Cassette1.
Paper jam at Cassette2.
Paper jam at Mp Tray.
Paper jam at Document
Processor.
Paper jam in printer.
Place original and press
[Start].
Print overrun
This page isn't complete.
Remove originals in
document processor.
Replace Toner.
Scan memory overflow. Job
is ended.
7-6
A paper jam has occurred. Press the left [Select] key to
cancel the copying procedure.
Refer to Paper Jams on page 7-8 and remove the
jammed paper.
The machine will attempt to make copies from any
originals that remain uncopied.
Reset all of the originals on the original table and try to
copy again.
A data overrun error has occurred due to insufficient
memory.
To continue printing, press the right [Select] key.
To cancel printing, press the left [Select] key.
This appears if there is a document in the document processor
when the power is turned on. It also appears when the paper
has jammed while being fed from the document processor
because of the way it was placed.
Remove all the document pages inside the document
processor, and position them again correctly.
Toner has run out so further copying or printing is
impossible.
Replace the Toner Container.
Scan memory overflow. Job is ended. Press the left
[Select] key to cancel the copying procedure.
There is insufficient memory available. To verify the
current amount of memory, print out a Status Page. Add
memory if necessary.
To cancel printing, press the right [Select] key. If Auto
Error Clear is set to On, printing will be automatically
resumed after a preset period of time. Refer to the
Advanced Operation Guide.
Try adding more memory. Refer to Expansion
Memory on page 5-7
Procedure
Reference
Page
Refer to page
7-8
—
—
Refer to page 7-
12
Refer to page
6-3
—
BASIC OPERATION GUIDE