Table of Contents
Advertisement
TR-101
5.2 Button description
Power button
SOS button
Answer / Hang up
Quick dial 1 /
Volume up
Quick dial 2 / Mute
the microphone
Quick dial 3 /
Volume down
GSM LED
GPS LED
Power LED
Power adapter jack
Mini USB
connector
Button Lock
Turn on / Turn off: Please see 7.1 for details.
You can assign up to 3 sets of phone numbers to the SOS button. When this button is pressed, TR-101 will send it's
location information to these 3 sets of phone numbers by SMS.
TR-101 will first call the SOS number 1 and send the location information by SMS. Following, TR-101 will repeat the
same procedure to SOS number 2 and 3.
When there is a incoming call, press this button to answer the incoming call. While in talking, press it will hang up the
phone.
You can set a phone number for this button; when this button is pressed, TR-101 will dial the preset number.
While in talking, you can press this button to increase the volume.
You can set a phone number for this button; when this button is pressed, TR-101 will dial the preset number.
While in talking, the other party will not hear from you if this button is pressed to mute the microphone; press it again to
enable the microphone.
You can set a phone number for this button; when this button is pressed, TR-101 will dial the preset number.
While in talking, you can press this button to decrease the volume.
LED is on: TR-101 is turned on, but not connected to GSM network yet.
Blinking quickly (once per second): TR-101 is in dialing or talking mode.
Blinking slowly (once per 3 seconds): TR-101 is in the standby mode.
When TR-101 is turned on, the GPS LED will be blinking for about 3 minutes for searching signal and fixing location. If
the GPS signal is acquired and location is fixed, the LED will light on for 2~3 seconds, and then turned off.
If it can not acquire the GPS signal within 3 minutes, the LED will be turned off directly.
The LED will be orange when AC adapter is plugged for charging the battery. If the battery power is low, this LED will
be on in red.
Plug in the Power adapter to TR-101's power adapter jack for battery charging.
Connecting TR-101 to PC by a Mini USB cable, you can setup all its features and functions from an application
software in PC.
Switch to lock all the buttons for the purpose of preventing buttons from been accidentally touched. (Only the power
button is not lockable. When Button Lock is on, the LED indicators will flash 3 times if any other button is pressed.)
Advertisement
Table of Contents
