Table of Contents
Advertisement
Getting started
Attaching the parts
1
Attach the document
tray by inserting it
into the appropriate
holes, as shown.
2
Attach the paper hopper into the
appropriate hole, as shown. Press
gently until the hopper won't go
in any farther.
3
Attach the document hopper by
inserting its two pegs at a
slightly upward angle into the
appropriate holes, as shown.
Plug in and power up
1
Plug one end of the telephone line
cord into the
jack on the back of
LINE
the machine. Plug the other end of
the cord into a standard telephone
wall jack, just as you would plug in a
phone.
2
Plug the non-pronged end of the
into the
power cord jack on the left side of the
AC
machine.
3
Plug the pronged end of the
a 120
electrical outlet (use a surge suppressor, as mentioned on page 1.6).
VAC
1.8
Document
Paper hopper
hopper
power cord
AC
power cord into
AC
4
Use the
power switch on the front of
AC
the machine to turn it on. The markings
are international standards: I means on,
O means off.
Setting the paper size for the multipurpose tray
The multipurpose tray can hold either letter- or legal-sized paper for your machine.
All you have to do is tell the machine which size the tray is holding.
Important: If you use a different size from the size you set here, the machine
won't print. Be sure to change this setting whenever you load a
different paper size.
1
Press /
,
, 0, 4,
PROGRAM
J
ENTER
Paper Size:
Letter
Program/Enter
2
Press
or /
until the paper size you want to load appears.
PROGRAM
In this example, we've chosen legal-sized paper.
Paper Size:
Legal
Program/Enter
3
Press
to save the setting.
ENTER
Adjusting the monitor speaker's volume
To adjust the volume of the monitor speaker:
1
Press
/
on the control panel. You should hear a dial tone, and the
MONITOR
CALL
display shows:
**
Tel Mode
**
_
Important: If you don't hear a dial tone, make sure your fax machine is
plugged into a working phone line.
. The
shows the tray's current setting:
LCD
Advertisement
Table of Contents
