Table of Contents
Advertisement
8. Other Basic Functions
8.6.2 Recall Job Settings
8.7 Density Shift
Density Shift 0 to 5; 3 is the
standard setting and is factory-set
in the system.
– On the operating panel, press the JOB MEMORY key.
– Select the desired job by pressing the job number. If necessary, use the
arrow key to display the required job memory key on the screen.
Confirm your selection with OK; or press JOB CHECK to display the
settings programmed in this job.
– The system is now set to the selections of the recalled job.
– After copying, you can recall the initial settings by pressing AUTO RESET.
– In Reserve mode (i.e. while a job is being processed) job settings cannot
be recalled.
Density shift 5
The 9 manual density settings can be individually adjusted to a lighter or
darker scale for each mode.
– Press SPECIAL ORIGINAL in the Basic Screen. In the Enhance mode
various density settings can be adjusted.
– Press e.g. Photo and then P to adjust this mode.
– You can now adjust the density scale between 0 (dark) and 5 (light).
The set value is indicated in the message area of the display.
– For adjustments to the other modes (AUTO refers to Text/Photo mode)
press the corresponding key and then P to call up the Density Shift
mode.
– Once you have completed the adjustment, press STOP to leave the
Density Shift mode.
Density shift 0
Density shift 1
Density shift 2
Density shift 3 (standard)
Density shift 4
39
Advertisement
Table of Contents
