Paper Size Selection; Multi-Sheet Bypass For Special Paper Size/Type - Konica Minolta 7075 Instruction Manual

Hide thumbs Also See for 7075:

Table of Contents

7. Simple Copying

7.4.4 Paper Size Selection

Load tabbed sheets always as

complete sets. They have to be

positioned face up so that the

tabs are on the right at the rear of

the multi-sheet bypass tray. If TAB

is selected, double-sided copying

(132 and 2 32) is not possible.

– In this screen, simply press on the desired paper size. Your originals will

then automatically be reduced or enlarged onto the selected copy size

(AMS).

– If you press APS, the copier looks for the size corresponding to the

original size. Same-size copies will be produced. If paper of the same

size is not available, the image will automatically be rotated by 90°,

providing this is possible (e.g. from A4 to A4R). If no suitable paper size

can be detected, you will be prompted with a user instruction to supply

the missing paper size.

– If you select the multi-sheet bypass tray, the basic screen will display the

PAPER TYPE/SIZE key. Press this key to call up the screen shown

above.

– If you want to process special material (e.g. OHP films, transparancies,

tabs), please press the corresponding key. Copying onto tabs is not pos-

sible.

– STD size (special) and Non STD size allow copying onto unusual

paper sizes. Use the arrow keys on the popup screen displayed above

to enter the desired size. If no suitable paper size is available a further

popup screen can be called up under Non STD size to enter the des-

ired horizontal and vertical dimensions.

Table of Contents