The height adjustable
feet at the front and rear can all
be adjusted from the front.
Front:
with open ended wrench 1/2" (SW13)
Rear:
with 5/1¢" (8 mm) hex nut driver
via flexible shaft.
A mark is attached
to the appliance
base and is used as
a standard
gage for height adjustment.
When adjusting
the height, align this mark at a height of 1 _A"(32 mm)
above the floor.
12.
C3
Attaching
the appliance
to the
top of the cavity
Screw the attachment
plate tugs (top) to the
overhead
furniture/fixtures.
[3
Unscrew
the height adjustable
feet until the mark
on the base has reached the indicated guide
dimension
(11/4"/ 32 mm).
[_lt
is very important
to comply
with this dimension
for
the subsequent
alignment
of the furniture fronts.
C3 Align the furniture fronts with the spirit level.
_i]
Note:
Do not twist or jam the appliance
inside the cavity!
When unscrewing
the height adjustable
feet,
proceed
gradually:
Always alternate between
left
and right, left and right, etc..
The adjustment
of the rear feet is facilitated
if the
appliance
is unloaded
at the rear.
If using a wooden
beam as an alternative
anti tip
device according
to point 6 of this installation
manual, rotate the appliance
all the way towards
the wooden
beam.
[3
Fix the attachment
plate side tugs (top) depending
on the installation
situation.
If there is no gap or only
a slight gap, it is not necessary to fix the side tugs.
C3
If there is a fairly large gap above the appliance,
fit a
wooden
beam above the appliance,
ensuring that
the wooden
beam fits the gap exactly.
22