Attaching An Alternative Anti Tip Device - Thermador T24IF70NSP/03 Installation Instructions Manual

a. b. c.
[_ Note
If the installation cavity is deeper than the appliance,
select a beam which has a larger cross section or
attach 2 beams.
The beam must cover the appliance by at least 2"
(50.8 mm).
C3 Manually insert the screw into the walt plug until the
screw begins to resist.
C3 Knock the walt plug and screw into the hole until the
screw head is approx. 1/2"(13 mm) from the anti tip
bracket.
C3 Tighten the screw.
6. Attaching an alternative anti-tip
device
If possible, always screw the wooden beam to
existing studs on the rear panel of the cavity.
If the anti tip brackets cannot be attached securely,
an alternative anti tip device can be attached.
However, ensure that there is no play between the
appliance and the anti tip device.
[3 Saw the wooden beam (cross section min. 3" x 4")
to the required length.
Length is equal to the width of the installation cavity!
(2i 26,1)
€ _/32
_lmm
[3 Mark the installation height (lower edge of the beam)
on the rear panel of the cavity.
C3 Select screws according to the thickness of the
wooden beam: length - min. 2.5 x beam thickness,
diameter #12 or #14.
C3
C3
C3
Specify the number of screws according to the
cavity width, thereby ensuring that the beam can
be attached securely.
Locate watt studs near the rear panel of the cavity
and mark drill holes in the beam.
Predritt the wooden beam.
Attach the wooden beam to the rear panel of the
cavity.
19