Installing And Aligning The Appliance - Thermador T24IF70NSP/03 Installation Instructions Manual

[_ When the floor or the appliance is tilted in
comparison to the installation cavity adjust height
adjustable wheels before you move the appliance
into the installation cavity.
C3 Put the mains plug into the socket.
[_ln the case of Side by Side appliances a separate
socket must be used for each appliance.
C3 Prevent the power cord from becoming
caught.
Tie a piece of string to the middle of the power cord
and feed forwards under the appliance. When
pushing in the appliance, pull the cable forwards.
or
C3
Using adhesive tape, stick the power cord to the
floor centrally behind the appliance approx. 15"
(380 mm) away from the rear panel of the cavity.
Carefully push the appliance into the cavity until
the height-adjustable wheel interlock with the
anti tip brackets.
11. Installing
and aligning the
appliance
Caution when pushing the appliance into the
installation cavity. Do not damage the water pipe
or power cord attached to the floor.
C3 Align the appliance
with the furniture fronts.
Place marking out level over the installation aid
parts on the door.
The installation aid parts on the door have been
designed for the following total thickness of furniture
doors:
3_,, (19 mm)
11/2" (38 mm)
Always take account of the possible differing
thickness of the furniture fronts which are to be
fitted subsequently.
C3 Remove edge protection.
21