Table of Contents
Advertisement
The height-adjustable
feet at the front and rear can all
be adjusted from the front.
Front:
with open-ended
wrench
1/2" (SW13)
Rear:
with 5/16" (8 mm) hex nut driver
via flexible shaft.
Never use a cordless
screwdriver!
A mark is attached
to the appliance
base and is used as
a standard
gage for height adjustment.
When adjusting
the height, align this mark at a height of 1 V4"(32 mm)
above the floor.
(32 mm)
Q
Unscrew
the height-adjustable
feet until the mark
on the base has reached the indicated
guide
dimension
(11/4"/ 32 mm).
IT]It
is very important
to comply with this dimension
for
the subsequent
alignment
of the furniture fronts.
Q
Align the furniture fronts with the spirit level.
%
13,
Note:
Do not twist or jam the appliance
inside the cavity!
When unscrewing
the height-adjustable
feet,
proceed
gradually: Always alternate between
left
and right, left and right, etc..
The adjustment
of the rear feet is facilitated
if the
appliance
is unloaded
at the rear.
If using a wooden
beam as an alternative anti-tip
device according
to point 6 of this installation
manual, rotate the appliance
all the way towards
the wooden
beam.
Attaching
the appliance
to the
top of the cavity
83
Screw the attachment
plate lugs (top) to the
overhead
furniture/fixtures.
27
Advertisement
Table of Contents
