Attaching The Adjusting Rail To The Furniture Door - Thermador T24IF70NSP/03 Installation Instructions Manual

18. Attaching the adjusting rail
to the furniture door
[_The adjusting rail is the most important means of
adjusting the furniture front.
C3 Unscrew the installation support part from the
appliance door.
[_ Check the double threaded bolts on the adjusting
rail. Both of them must project out of the door by
3/16" (5 mm).
4X15
C3 Mark this amount X on the rear of the furniture door.
C3 Determine and mark the centre of the furniture door.
C3 Loosen the 2 nuts and remove the adjusting rail.
C3 Put on the adjusting rail and align along the marks.
Mark the drill holes.
C3 Drill the holes.
C3 Screw on the adjusting rail tightly.
[_ Note
Attach the adjusting rail to the furniture door with at
least 6 screws. One screw should be inserted under
each double threaded bolt.
18" _ 6x
4 _
6x
30"
lOx
lOx
Measure the distance X between the adjusting rail
and the overhead furniture/fixtures.
The adjusting rail features a variety of holes for the
many different design options of furniture doors.
Always screw into the best toad bearing material
of the furniture door.
27