Loading The Appliance Door; Attaching - Thermador T24IF70NSP/03 Installation Instructions Manual

Function of different parts: In the case of 30" and 36" wide appliances 2 adjacent
furniture doors can be attached instead of one large
door. These furniture doors must be connected to
a metal strip on the rear.
This metal strip can be purchased from customer
service as an optional accessory, see the section on
"Optional accessories" on page 13.
1. Double threaded bolt on the adjusting rail:
for vertical adjustment of the furniture door.
2. a) Side brackets:
for adjusting the depth of the furniture front.
b) Fixing plates:
for lateral adjustment of the furniture front.
3. Nuts on the double threaded bolt:
for securing the furniture front to prevent lateral
movement.
4. Lower brackets:
for securing the furniture front to prevent lateral
movement.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and
the position of the drill holes. Always screw into the best
toad bearing material of the furniture door.
[_lf only one furniture door is to be attached to the
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.
17. Loading the appliance door
When attaching the furniture doors, it is recommended
to toad the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
18" Appliance 22 tbs / 10 kg
24" Appliance 33 tbs / 15 kg
30" Appliance 44 tbs / 20 kg
26