Removing The Memory Carrier Assembly - HP Integrity rx6600 User's & Service Manual

WARNING!
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
ESD safety precautions can result in damage to the server.

Removing the Memory Carrier Assembly

To remove the memory carrier assembly, follow these steps:
1. Power off the server and disconnect the power cables. See
(page 90).
2. If rack installed, slide the server out from the rack until it stops. See
the Rack" (page
3. Unlatch the cover release lever on the top cover and remove the memory carrier assembly
cover. See
NOTE:
the top cover release lever must be open.
4. Press the button located in the center of the memory carrier assembly to release the extraction
handles
CAUTION:
result in damage to the extraction handles.
5. Pull up on the extraction handles, and rotate them outward approximately 90 degrees
(Figure 67).
NOTE:
6. Pull the extraction handles to lift the memory carrier assembly out of the chassis
NOTE:
inward and snapping them into the locked position when servicing the system DIMMs or any
time the carrier is out of the chassis. Before replacing the memory carrier assembly, press the
button to release the extraction handles. Use the handles to replace the memory carrier into
the chassis.
Ensure that the system is powered off and all power sources have been disconnected
Observe all ESD safety precautions before attempting this procedure. Failure to follow
176).
"Removing the Memory Carrier Assembly Cover" (page
You do not need to fully remove the top cover to service this component; however,
(Figure 67).
Manipulate the extraction handles with care; failure to observe this caution can
The extraction handles latch into the open position with an audible click.
To avoid damage to the extraction handles, HP recommends rotating the handles
"Powering Off the Server"
Removing and Replacing the Memory Carrier Assembly 203
"Extending the Server from
179).
(Figure 67).