Replacing A Hot-Swappable Power Supply; Removing And Replacing A Hot-Swappable Disk Drive Filler - HP Integrity rx6600 User's & Service Manual

Figure 60 Removing and Replacing a Hot-Swappable Power Supply

Replacing a Hot-Swappable Power Supply

To replace a hot-swappable power supply, follow these steps:
1. Remove the metal filler panel if required.
2. Support the new power supply with both hands, and slide it into the empty slot until it clicks
into place
IMPORTANT:
panel.
3. Plug the power cord into the power supply receptacle.
NOTE:
4. Replace the cable management arm.

Removing and Replacing a Hot-Swappable Disk Drive Filler

Disk drive fillers are installed for all slots that do not contain a disk drive.
IMPORTANT:
disk drive.
186 Removing and Replacing Server Components
(Figure 60).
Ensure the power supply is flush with the adjacent power supply or metal filler
The LED immediately turns on when power is applied.
For cooling purposes, always leave disk drive fillers in slots that do not contain a