Replacing The Midplane Board - HP Integrity rx6600 User's & Service Manual

Figure 88 Midplane Board

Replacing the Midplane Board

To replace the midplane board, perform these steps:
1. Place the midplane board onto the guide pins on the chassis wall. Push straight down until it
seats onto the locking studs.
2. Use a Torx 10 screwdriver to replace and tighten the four Torx screws attaching the midplane
board to the sheet metal bracket through the rear of the chassis
3. Swing the hinged CPU panel up to expose the midplane screw holes. Use a Torx 10 screwdriver
to replace and tighten the three Torx screws attaching the midplane board to the sheet metal
bracket through the front of the chassis
4. Reconnect the fan cables into the fan 1 and fan 2 housing units.
a. Guide the cable connector up through the opening in the fan housing.
b. Push the cable connector toward the front of the chassis until the connector tabs seat into
place.
5. Replace the trap door and slide it toward the front of the server.
6. Replace the power supplies. See
7. Replace the I/O board assembly. See
8. Replace the interconnect board. See
9. Replace the lower SAS backplane board. See
250 Removing and Replacing Server Components
(Figure 87).
"Replacing a Hot-Swappable Power Supply" (page
"Replacing the I/O Board Assembly" (page
"Replacing the Interconnect Board" (page
"Replacing the SAS Backplane Board" (page
(Figure 86 ).
186).
225).
246).
244).