HP Integrity rx6600 User's & Service Manual page 292

Expander Spinup Delay
Expander Max Target Devices
PHY Properties Screen
The PHY Properties screen enables you to view and modify PHY specific settings. To access PHY
Properties, press Enter on the PHY Properties field from the Advanced Adaptor Properties screen.
You can perform the following actions from PHY Properties:.
To display the next PHY, press N.
To display the previous PHY, press P.
To reset the Link Error Counts for this PHY or all PHYs, press Enter on Reset Link Error Counts.
Resetting Link Error Counts issues a PHY Link Error Reset. The following prompt displays when
you press Enter:
Are you sure you want to reset Phy error counts?
Reset error counts for this Phy only
Reset error counts for all Phys
Cancel
NOTE: The Link Error Settings values on this screen display the current values for this PHY only,
and are not modifiable. To modify the Threshold values, you must return to Advanced Adapter
Properties screen.
PHY
SAS Port
Link Status
Discovery Status
Device Identifier
Scan Order
Device Information
292 Core I/O Card Utilities
Expanders are not supported.
Expanders are not supported.
Displays the PHY number current information.
Indicates the associated SAS Port (0 to N) as configured on this
adapter.
Indicates the PHY link status. Possible values are:
Enabled, Unknown Link Rate
PHY Disabled
Enabled, negotiation failed
Enabled, SATA OOB Complete
Enabled, 1.5 Gbs
Enabled, 3.0 Gbs
32 bit hexidecimal value indicating the discovery status for the PHY
or Expander. Currently defined values are:
Discovery completed successfully - 0x00000000
Loop Detected - 0x00000001
Unaddressable device exists - 0x00000002
Multiple Ports - 0x00000004
Expander Error - 0x00000008
SMP Timeout - 0x00000010
Out of route entries - 0x00000020
SMP Response Index Does Not Exist - 0x00000040
SMP Response Function Failed - 0x00000080
SMP CRC error - 0x00000100
Indicates the ASCII device identifier string extracted from the device's
Inquiry Data.
Indicates the scan order for this device (equivalent of a SCSI ID for
parallel SCSI).
Indicates if a device is SAS.