Install The Water Inlet Hose - Haier XQB60-C User Manual

Install the water inlet hose

Install the water inlet pipe
Water faucet, suitable
It is required that the front end shall be longer than 10mm.
The outlet end surface of the faucet shall be flat and smooth. If not, please file it smooth to avoid leakage.
Connection between the water inlet hose jointer and the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the
water inlet hose component. See to Figure 1.
2 Loosen the four screws of the water inlet hose jointer till the water faucet can be accessed. Then set the water inlet hose
jointer on the faucet. See to Figure 2. If the faucet is too large and the jointer cannot be set on, please loosen the four
screws and take out the bush inside the jointer. See to Figure 3.
Lock level
Water inlet hose
3 Fasten the four screws of the water inlet hose jointer evenly. See to Figure 4.
4 Take off the nameplate. Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
Remark: .Before installation, the threading is 4mm above the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut..
Figure 4
Connection between the water inlet hose and the washing machine
1 Do not take off the water absorption cushion. Please check
if the cushion is dropped or damaged each time before using.
If it happens so, please duly contact our after-sale service
department.
2 Set the nut of the water inlet hose on the water inlet valve jointer.
3 Fasten the nut. Swing it gently to confirm if it's fastened well.
Water inlet hose jointer
Slider
Screw knife
Figure 1
Figure 5
Water inlet valve jointer
Before Using
water faucet, not suitable
Screw
Nameplate
Figure 2
About 4mm after twisting
About above 2mm after twisting
Screw nut
Water inlet
hose nut
Water absorption cushion.
Before Using
Bushing
Figure 3
Figure 6
5