Trouble-Shootinganswers To Questions - Haier XQB60-C User Manual

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
Phenomenon
The wash, rinse spin and gentle s lamps are
flashing. The machine does not spin.
The wash, rinse, spin and jeans s lamps are flashing.
The drainage cannot work, or is too slow.
The safety switch acts, and the spinning
cannot work. The wash, spin, jeans and
speedy s lamps are flashing.
The machine
Not wash
does not act.
Not spin
There's abnormal sound inside
the machine
The water faucet leaks water
No water inlet.
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the SPIN button, but it doesn't act.
There may be some water flowing out of the drain
hose in the first use of the machine.
The pulsator pauses during water filling in washing and rinsing.

Trouble-shootingAnswers to questions

Trouble-shootingAnswers to questions
Trouble-shootingAnswers to questions Trouble-shootingAnswers to questions
Reason
The top lid is opened.
Is the drain hose blocked?
Are the laundries put slantingly?
Is the machine slanting?
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are there any foreign materials?
Are the laundries put slantingly in
spinning?
Is the screw of the water inlet hose
jointer loose?
Is the screw of the water inlet hose
jointer twisted awry?
Is the power plug plugged tightly?
Is the water faucet opened?
Are the POWER ON/OFF and
START/PAUSE buttons pushed down?
How to solve
Close the top lid.
Clean the foreign material. Push
the start button again.
Reorder the laundries. Close the top lid.
Set the washing machine horizontally and
then open and close the top lid once.
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even
Remove the foreign materials.
Reorder the laundries and close the top lid.
Fasten the screw of the jointer properly.
Plug the power plug tightly.
Open the water faucet.
Push the power ON/OFF button and
START/PAUSE button.
Explanation
It is to balance the laundries to avoid slanting.
The program is setting the drain time. A certain
period is needed before it starts spinning.
It is the water remained in the machine during the
ex-factory performance inspection.
It is to avoid splashing during water filling.