Install The Water Inlet Hose - Haier HWMP55-918 User Manual

Install the water inlet hose

Install the water inlet hose
Use the new hose supplied, do not reuse old hoses.
1. Insert a new flat washer into each end of the inlet hose. Firmly put the
washers in the coupling.
Note:
Use the new hose supplied with the washer.
Any other old hoses should not be used.
You may have to use pliers to tighten the coupling.
Do not overtighten because you may cause
damage to the valve.
2. Connect the water inlet hose to the water faucet.
3. Connect the other ends to their respective cold and hot water inlet valve
located at the rear of the washer
to Joiner of the water inlet valve
4.Fasten the nut. Swing the hose gently to confirm that the hose is
securely fastened.
Check the connection between the
water inlet hose and the water tap
1.Swing the hose gently to confirm that the hose
is securely fastened.
2.After installation, open the tap to check for leaks..
3.Do not bend the hose unduly.
4.Before every use check the hose connections are
firm at both ends. This is to ensure the connections
remain firm over time.
Remove the water inlet hose
1.Close the water tap.
2. Remove the water inlet hose from the water tap and washer.
Nut of the water inlet hose
Water absorption cushion
6