Important Safety Information - Hatco HWB Series Installation & Operating Manual

IMPORTANT! Read the following important safety instructions to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
To prevent electrical shock or injury, turn the
power switch OFF, disconnect the unit from
the power source and allow to cool before
performing any maintenance.
The Built-In Heated Wells are not waterproof.
To avoid electrical shock or personal injury,
DO NOT submerge in water. Do not operate if
it has been submerged in water.
Risk of fire, install Built-In Heated Well
a minimum of 3-1/2" (89 mm) from all com-
bustible surfaces per assembly instructions.
To avoid any injury or damage Hatco
mounting kits must be used when mounting
unit in a combustible countertop.
Remote control panel must have at least a
6" (152 mm) clearance from the Built-In
Heated Well, not to exceed 72" (1829 mm).
For proper and safe operation the remote
control panel location must be mounted on a
vertical wall.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
To avoid injury or damage to the unit, do not
use harsh chemicals such as bleach or
cleaners containing bleach, oven cleaners,
or flammable cleaning solutions to clean the
Built-In Heated Wells.
The drain water may reach temperatures in
excess of 200° (93°C). To avoid any injury or
damage to the unit use appropriate plumbing
materials when installing drain.
To avoid any injury or damage to the unit turn
unit off when filling with water and avoid
splashing.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-
2966 or International fax 414-671-3976.

IMPORTANT SAFETY INFORMATION

This product has no "user" serviceable parts.
To avoid damage to the unit or injury
to personnel, use only Authorized Hatco
Service
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are
specified
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn.
To avoid any injury or damage locate the unit
at the proper counter height, in an area that
is convenient for use. The location should be
level and strong enough to support the
weight of the unit and food product.
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a
minimum of 70°F (21°C) and a maximum of
85°F (29°C).
To avoid injury or damage to the unit DO NOT
clean the unit while it contains any food
product. Remove food product and allow unit
to cool completely before cleaning.
1
Agents and Genuine
to operate safely
CAUTIONS
Form No. HWBM-0206
Hatco
in the