DRAIN ASSEMBLY MODELS
WARNING
The drain water may reach temperatures in
excess of 200° (93°C). To avoid any injury or
damage to the unit use appropriate plumbing
materials when installing drain.
Drain Assembly (See Figure 13)
After installing unit in countertop, install the drain
assembly as follows:
Note: For proper drain plumbing installation to
conform to local plumbing codes consult a licensed
plumbing contractor.
1. Connect one end of drain pipe (supplied by
others) to 3/4" NPT drain fitting.
2. Connect other end of drain pipe to drain valve,
(supplied by others).
3. Drain valve may connect to external drain pipe if
desired.
WARNING
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
WARNING
To avoid any injury or damage to the unit turn
unit off when filling with water and avoid
splashing.
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
Place appropriate sized food pan into the Built-In
Heated Well opening.
POWER ON/OFF
Place the On/Off switch in the "ON" position. The
indicator light glows when the unit is on. (See
Figure 14.)
TEMPERATURE CONTROL
Turn thermostat control knob to adjust the
temperature of the Built-In Heated Well to the
desired safe food temperature.
Figure 13. Drain Connection
Thermostat Control Knob
Figure 14. Control Panel
15
INSTALLATION
Drain
Fitting
OPERATION
On/Off Switch
Form No. HWBM-0206