Important Safety Information - Hatco MDW Series Installation And Operation Manual

Read the following important safety information to avoid serious injury or death and to
avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine and install the proper voltage and
size electrical outlet.
• Turn the power switch OFF, unplug the power
cord, and allow the unit to cool before
performing any maintenance or cleaning.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if unit
has been submerged or saturated with water.
• Unit is not weatherproof. Locate the unit
indoors where the ambient air temperature is
a minimum of 70°F (21°C) and a maximum of
85°F (29°C).
• Do not steam clean or use excessive water on
the unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or
worn.
• Do not attempt to repair or replace a damaged
power cord. The cord must be replaced by
Hatco, an Authorized Hatco Service Agent, or
a person with similar qualifications.
• Use only Genuine Hatco Replacement Parts
when service is required. Failure to use
Genuine Hatco Replacement Parts will void
all warranties and may subject operators of
the equipment to hazardous electrical
voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are
specified to operate
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment.
FIRE HAZARD: Locate the unit a minimum of
1" (25 mm) from combustible walls and
materials. If safe distances are not maintained,
combustion or discoloration could occur.
Use only light bulbs that meet or exceed
(National Sanitation Foundation (NSF) standards
and are specifically designed for food holding
areas. Breakage of light bulbs not specially
coated could result in personal injury and/or
food contamination.
Form No. MDWM-0608
All manuals and user guides at all-guides.com

IMPORTANT SAFETY INFORMATION

safely in the
This unit has no "user-serviceable" parts. If
service is required on this unit, contact an
Authorized Hatco Service Agent or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
BURN HAZARD: Some exterior surfaces on the
unit will get hot. Use caution when touching
these areas.
Locate the unit at the proper counter height in an
area that is convenient for use. The location
should be level to prevent the unit or its contents
from falling accidentally and strong enough to
support the weight of the unit and contents.
Do not lay unit on the side with the control panel
or damage to the unit could occur.
Use non-abrasive cleaners only. Abrasive
cleaners could scratch the finish of the unit,
marring its appearance
susceptible to soil accumulation.
1
WARNING
CAUTION
NOTICE
and making it