Hatco HWB Series Installation & Operating Manual page 15

Remote Mounted Control Panel
WARNING
For proper and safe operation the remote
control panel location must be mounted on a
vertical wall.
CAUTION
To assure proper operation the remote mounted
control panel must be installed in the vertical
position.
CAUTION
The remote mounted control panel should be
installed outside of the heat zone. Locating the
control panel inside the heat zone will cause the
control(s) to overheat, malfunction, and fail. See
Figure 12 for maximum mounting distances.
NOTE: A qualified electrician is recommended for
connecting the Heated Well units to a power source.
1. Remove trim cover from control panel assembly.
2. Position control panel into opening through the
backside.
3. Secure control panel to surface using screws
(not supplied).
4. Connect proper power source to the mounted
remote control panel.
5. Reinstall trim cover.
NOTE: Standard units are equipped with a 36"
(914 mm) flexible conduit connected to the control
panel. 72" (1829 mm) flexible conduit option
available (not for retrofit).
13
INSTALLATION
Form No. HWBM-0206