Table of Contents
Advertisement
INSTALLATION
UNPACKING
1. Remove the unit from the carton and remove all
packing materials.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in warranty card.
WARNING
To prevent any injury or damage to the unit do
not pull unit by power cord.
WARNING
To prevent any injury, discontinue use if power
cord is frayed or worn and contact Authorized
Service Agent to replace it.
ELECTRICAL WIRING HOOK-UP
Refer to the ELECTRICAL RATING CHARTS for
specific information.
Install an approved grounded receptacle to match
the plug and cord supplied with the unit.
WARNING
All electrical connections must be in accordance
with local electrical codes and any other
applicable codes. Connections should be made
by a qualified, licensed electrician.
LOCATION
CAUTION
To avoid any injury or damage locate the unit at
the proper counter height, in an area that is
convenient for use. The location should be level
to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food.
WARNING
For safe and proper operation, the unit must be
located a a minimum of 2" (51 mm) from
combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
WARNING
To prevent any injury or damage to the unit do
not store or use gasoline or other flammable
vapors or liquids in the vicinity of this or any
other appliance.
Form No. GRFSM-0307
All manuals and user guides at all-guides.com
6
Post Mount
Top Housing
Figure 7. Securing Mounting Post
G L O
-R A Y
FO OD
WA RM
ER
HAT CO
CO RP
MIL WA
UKE E,
WI U
S A
CAU TIO
N MA
XIM UM
LAM P
SIZ E
60W
Bolt
Countertop
Figure 8. Mounting Unit
ASSEMBLY
GRFS, GRFSL, GRFSC, & GRFSCL Models
WARNING
To avoid risk of fire the Fry Station Foodwarmer
must be assembled and mounted properly
before turning on power to the unit.
1. Remove top housing and post mount from carton
and set parts on a non-scratch surface.
2. Remove all packaging materials from unit.
3. Position the top housing, element side up, on a
non-scratch surface.
4. Loosen phillips head screw located near the top
of post mount. Slide post mount onto top housing
and secure by tightening phillips head screw.
(See Figure 7.)
Phillips Head Screw
Washer
Washer
Nut
Advertisement
Table of Contents
