Table of Contents
Advertisement
Cor necting
gas to your dryer
Usecompound or thread tape appropriate to the gas type that is to be used (Natural or LP Gas),
on the male threads of all non-flared connections.
Never use an open flame to test for gas leaks.
This dryer will operate satisfactorily
up to altitudes
of 650Oft (2000m) above sea level at the
BTU rating indicated
on the model/serial
plate. Burner input adjustments
may be required if
operating
above this elevation.
The dryer must be isolated from the gas supply piping system by closing the supply shut-off
valve during any pressure testing of the gas supply piping system.
Gas ignition
This dryer has an automatic
ignition
system to ignite the burner. There is no [allot flame
burning
in this dryer.
Connecting
to the gas supply
1.The gas supply
line should
be V2inch.
2. A shut-off
valve must be installed
on the gas supply
line within
6ft (1.8m) of the dryer.
3, An 1/8 inch NPT plugged
tapping
must be installed
to allow the gas inlet pressure
to be
checked.
%" NPT plugged tapping
Gas shut off valve
I/2" NPT gas supply line
19
Advertisement
Table of Contents
