Advertisement
Draining
The dryer is equipped with a condenser unit which accumulates water during the drying cycle. This water is
collected in the removable water tank located at the top left of the dryer. The accumulated water must be emptied
after each drying cycle. However you can also set up your dryer to drain automatically using the drain hose
provided.
Connecting the drain hose:
1. Remove the black hose from the connection at the back of the dryer (A).
2. Uncoil the drain hose (included with your dryer) and connect it to the black hose (B).
3. Place the other end of the drain hose into a tub or standpipe.
If you connect the drain hose onto your dryer and you do not secure the other end in a
drain, your dryer will drain water onto the floor. Ensure the drain hose is securely fixed in
place to an appropriate drain and is leak-free at the connection to the machine. Check the
connection and drain hose regularly.
• Maximum standpipe height is 1.0 m from ground level.
• Regularly check that your standpipe or tub is free from lint and other obstructions, which may affect drainage
and cause flooding.
• The drain hose should be checked from time to time and replaced if any damage, eg wear, cuts, bulges, kinks,
leaks, etc are found. Do not bend the drain hose sharply, as this may cause it to split.
• The extended length of the provided drain hose is 1.3 m.
• In multistory apartments or any upper floor, the machine should be installed on a floor equipped with a drain.
• Draining must comply with local by-laws.
Electrical connection
1. This appliance must be connected to a 220 V – 240 V, 50 Hz, sinusoidal, 10 A electrical supply.
2. Uncoil the power cord, remove and discard the plastic pin cover and plug into a power socket.
3. Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
https://producthelp.fisherpaykel.com/Manuals/Dryer_Manuals/User_Guides/428104B_Dryer/03_Installation_instructions
Updated: Sun, 09 Apr 2023 02:45:01 GMT
Powered by
4
Advertisement
