Table of Contents
Advertisement
To the installer
The correct installation of the dryer is your responsibility.
Be sure you read the following instructions carefully before you start to install the dryer. These
instructions should be left with the home owner for future reference.
It is your responsibility
to:
• Observe all governing codes and ordinances.
• Check code requirements. Some codes limit or do not permit installation of clothes dryers in
garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.
• Adhere to these installation instructions.
• Allow for spacing requirements with side by side installations (refer page 6).
• Make sure you have all items necessary for correct installation.
• Properly install the dryer.
• Contact a qualified installer to ensure that the electrical and gas installation meets all national
and local codes and ordinances.
Location
requirements
Explosion
Hazard
Keep flammable
materials and vapours, such as gasoline,
away from the dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a
garage installation.
Failure to do so can result in death, explosion,
fire, or burns.
The dryer must be installed or stored in an area which is not exposed to water or weather.
It is extremely
important
that the dryer is installed in a well ventilated
location. This dryer must
exhaust
air outdoors.
Do not install the dryer in any room or closet which does not permit the
free flow of replacement
air.
Before installing
the dryer ensure that there is sufficient
height to fully open the lid. Allow
sufficient
room behind the dryer for the exhaust. The air intake is at the rear of the dryer. Ensure
that there is a sufficient
air passage on each side of the dryer for intake air.
Advertisement
Table of Contents
