Table of Contents
Advertisement
WATER SUPPLY
Water supply requirements
Your cold water should not exceed 35°C. Temperatures above this may cause damage to
the dryer.
This appliance incorporates backflow protection complying with AS3500.1/IEC61770. No
further backflow protection is required for connection to the water supply.
Inlet hose(s)
Failure to adhere to the following guidance may result in a flood and damage to property.
Only use the new hose set(s) provided with your dryer.
The inlet hose setup requires the use of a third cold water inlet hose supplied with a
washing machine.
Water Supply
WASHER
1 Connect one of the inlet hose (1m) straight ends to the cold tap and the other to
the Y connector.
2 Connect the straight ends of the inlet hose (0.65m) and the washer inlet hose (1.5m)
(supplied with your washing machine) to the Y connector.
3 Connect the elbow ends of the inlet hoses to the dryer inlet valve and washer cold inlet
valve. Either hose may connect to either appliance depending on your configuration. Care
should be taken to avoid the Y connector resting against an appliance, as this may result
in a tapping noise.
4 Tighten the inlet hose ends by hand until the hose seal just makes contact with the
tap-sealing face. Continue to tighten a further half-turn.
5 Make sure there are no kinks in the hoses.
6 Turn the tap on and check for leaks. Check for leaks again after 24 hours.
Power Supply
Drain Hose
DRYER
The dryer is equipped with a condenser unit which accumulates water during the drying cycle.
This water is either collected in the removable water tank located at the top left of the dryer,
or you can setup your dryer to drain automatically using the drain hose provided.
We recommend the dryer is set up to drain automatically where possible especially when
drying full loads, this will avoid having to empty the water tank during a drying cycle.
In multi-storey apartments or any upper floor, the machine should be installed on
a floor equipped with a drain. Draining must comply with local by-laws.
Connecting the drain hose
1
2
3
DRAINING
Remove the black hose from the connection
at the back of the dryer.
Uncoil the drain hose (included with your
dryer) and connect it to the black hose.
Place the other end of the drain hose into a
tub or standpipe.
7
Advertisement
Table of Contents
