Setting The Macintosh Computer; For Mac Os X - Oce VarioLink 2221 User Manual

Setting up network printing
4
Specify settings for the following:
– AppleTalk: Set whether to use AppleTalk. Select "Enable" here.
– Printer Name: Specify the printer name (up to 31 alphanumeric
characters and symbols, excluding = ~).
– Zone Name: Specify the zone being connected to (up to 31
alphanumeric characters and symbols, excluding = ~).
5
To apply the settings, restart this machine (turn the main power off,
then on again).
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The
machine may not operate correctly if it is turned on immediately after
being turned off.

Setting the Macintosh computer

Use the Macintosh computer that is connected to specify the TCP/IP and
AppleTalk settings.
Note
For network settings, consult the network administrator.
For printer driver installation, refer to "Installing the printer driver" on
page 3-3.

For Mac OS X

1
On the Apple menu, select "System Preferences".
2
Click the "Network" icon.
3
From "Show", select "Built-in Ethernet".
For Mac OS X 10.5, select "Ethernet", and then click the [Advanced]
button.
4
Click the TCP/IP tab.
5
Select the items from "Configure" that correspond to the network
settings for the Macintosh computer that is connected to the network,
and then set the IP address and subnet mask.
VarioLink 2221/2821/3621
4
4-35