Inserting The Stiffening Plate - IBM 4820 Planning, Installation And Service Manual

Integrated touch pedestal instructions
Integrated touch pedestal
|
|
|
|
|
|
|
|
|
36
4820 Planning, Installation and Service Guide
See "Tailoring your installation" on page 11. This section describes how to install the
integrated touch pedestal to the wide 4694 and 4800 (wide and narrow) POS
terminals.
Mounting the 4820 to your system unit
Wide 4694 Point of Sale models: Follow these steps when installing the
integrated touch pedestal onto the wide 4694 models:
1. If applicable, remove the blank filler panel and printer.
2. Place the stiffening plate onto the 4694, aligning the holes in the plate with the
holes in the unit (As shown in Figure 35).
Figure 35. Inserting the stiffening plate
Note: Figure 35 illustrates the right-oriented placement of the arm. Rotate the
plate over for a left-oriented placement.
3. Fasten the counter-sunk washers and screws to the stiffening plate.
4. Route the cables as described for your 4820 model.
Update November 2005