Integrated Pedestal Covers - IBM 4820 Planning, Installation And Service Manual

Update November 2005
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
b. Place the display on the pedestal mounting bracket (see Figure 34).
Figure 34. Integrated pedestal covers
c. Secure the 4820 to the pedestal by using four screws.
Note: Ensure that you have attached the cables to the appropriate ports in the
back of the system unit.
4. Install the covers.
a. Attach the trough cover ( 1 in Figure 34) and cable cover ( 2 ) to the
mounting arm, snapping the tabs on the sides of the cover into the small
holes on the sides of the mounting bracket.
b. Attach the mounting bracket cover ( 3 and 4 ) to the back of the display.
Slide the tabs on the cover into the appropriate slots in the back of the
display and snap into place.
c. Position the trough cover over the trough of the integrated pedestal. Press
the trough cover until it snaps into place.
5. Plug the power cord into an outlet and power on the system unit. See "Power
usage" on page 9.
6. Go to "Adjusting the image" on page 53 and auto adjust your screen for
maximum viewing.
Integrated pedestal instructions for 5xx models
Chapter 2. Installing the IBM 4820
35