LifeSpan TR2000-HRC Owner's Manual page 23

Press and Hold Reset and then Speed Up
until the console beeps and the display changes. The
display just shows the date code and version of the
software
Press Mode
This is for turning the Intelliguard on and off. Intelli-
guard automatically pauses the unit if it detects the
treadmill is not being walked on. If 1 is in the lower
right corner then Intelli-guard is on. Use the up or down
buttons to select 0 to turn Intelli-guard off. If 0 is in the
lower right corner then Intelli-guard is off. Use the up or
down buttons to select 1 to turn Intelli-guard on.
Press Mode
The display changes to:
Press Mode
The display changes to:
Press Mode
The display changes to:
Press Mode
The Display changes to:
If you want to be in Si and it says En in the lower left
corner of the display press any of the up or down but-
tons til is says Si. The same goes for En. If it says Si
press the up or down buttons to change to En.
Press Mode
The Display changes to:
Dis stands for total distance the treadmill has been run
in miles or Kilometers depending on what mode the
treadmill is in. The right 4 digits show distance up to
9,999 miles or KM.
Press Mode
The display changes to:
Hur stands for total number of hours the tread-
mill has been used. The right 4 digits count up to
9,999 hours.
Press Mode and the unit goes back to run mode.
2000HRC – Console Engineering Mode
buttons
^
19
Console
2007 0907
Console
I – S
Console
Rol
599
Console
Ldu
Console
ISP 110
Console
En or Si
Console
dis 0
Console
Hur 0
1.00
1 or 0
4910
001
000
000