Installer; Nstaller Information; Unpacking And Inspection - HearthStone Sterling-Ht 8532 Owner's Manual & Installation Manual

Gas-fired direct vent heater
Table of Contents

Advertisement

HearthStone Quality Home Heating Products,
I
'
NSTALLER
S
Codes
Adhere to ALL local codes or, in their absence, the
latest edition of THE NATIONAL FUEL GAS
CODE ANSI Z223.1 (NFPA 54) or CAN/CGA B149
Installation Code, which can be obtained from:
AMERICAN NATIONAL STANDARDS
INSTITUTE, INC.
1430 BROADWAY
NEW YORK, NY 10018
NATIONAL FIRE PROTECTION
ASSOCIATION, INC.
BATTERY MARCH PARK
QUINCY, MA 02269
The appliance, when installed, must be electrically
connected and grounded in accordance with local
codes or, in the absence of local codes, with the
current NFPA 70-National Electrical Code or CSA
C22.1-Canadian Electric Code.
A manufactured home (mobile) OEM installation
must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (U.S.) or Standard for Manufactured Home
Installation, ANSI/NCBCS A225.1 or Standard for
Gas Equipped Recreational Vehicles and mobile
Housing,
CSA
Z240.4.CAN/SCA
(Canada).
(Installer l'appareil selon les codes ou
règlements locaux, ou, en l'absence de tels
règlements, selon les Codes d'installation CAN/CGA-
B149.)
C
F
L
S
ERAMIC
IBER
OG
If the decorative ceramic logs supplied with the
Sterling are damaged, they must be replaced. The
manufacturer, through your local HearthStone dealer,
supplies replacement parts. Do not replace ceramic
logs with any materials not approved by HearthStone
Quality Home Heating Products, Inc.
U
I
NPACKING AND
NSPECTION
Unpack and Inspect for Damage
The Sterling is packaged by the manufacturer to
withstand
normal
shipment
However, damage can still occur during transit, so
Inc
I
NFORMATION
OR
Z240
I
AFETY
NFORMATION
without
damage.
STERLING-Ht Gas-Fired Direct Vent heater
take care to inspect for damage when unpacking and
installing the unit. If any damage, or a missing part, is
detected, immediately contact your dealer. Do not
install or put into service a damaged or incomplete
heater.
The unit should appear to be square and level. The
sheet metal parts should be smooth and free of bends
or dents. The enameled cast iron should be free of
chips or cracks. If visible or concealed damage is
found, contact your dealer.
The decorative ceramic fiber logs supplied with the
Sterling are located in the firebox. Always use great
care when handling the decorative ceramic logs, as
they are very fragile and subject to damage and
breakage. To open the front, grasp both sides of the
front cast facade, toward the bottom, and lift upward
and then outward. The bottom will slide up and out.
The whole piece is then easily removed. Set the front
aside taking care not to chip or scratch the enamel.
Next, locate the two rotating clips above the glass.
Rotate the clips out of the "locked" position and tilt
the top of the glass outward. Lift the entire glass up
and out.
damage. To take the unit off the pallet, remove the
lag bolts, which fasten the unit to the pallet. Take
care not to chip the enameled legs. Have someone
help lift the stove off the pallet, and set it into place.
Packing List
MH
1-Sterling Gas-fired Heater containing:
3-Decorative Ceramic Fiber Logs
1-AA Battery
1-Owner's Manual and Warranty
1-Thermastat and wire
1-LP Conversion kit
5
The log set can now be inspected for

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents