Alarm Test; Alarm Smart Silence - FireAngel Thermoptek WST-630 User Manual

ALARM TEST

a) Briefly press the test button in the centre
and release.
b) The unit will give an audible alarm
consisting of 2 cycles of 3 loud beeps,
then stop automatically.
c) The red LED on the alarm will flash rapidly
during the audible signal.
NOTE: The test button tests the alarm's smoke
sensing circuit. There is no need to test your
alarm with smoke. If your smoke alarm fails
12
to give an audible test signal, please refer
immediately to the trouble shooting guide at
the end of this manual.
WARNING: As with all electronic alarm
products you should test your smoke
alarm every week.
If your WST-630 is interlinked with other
smoke alarms, we recommend that every
individual smoke alarm is tested during the
weekly test.
a) Briefly press the test button in the centre
of the smoke alarm and release.
b) The unit you are testing will give an
audible alarm consisting of 2 cycles of
3 loud beeps, then stop automatically.
The red LED on this alarm will flash rapidly
(once per second) during the audible
alarm. All interlinked alarms will give an
audible alarm consisting of 2 cycles
of 3 loud beeps, then stop automatically,
indicating the test is complete. The red
LED on all interlinked alarms will not flash
rapidly. If any alarm fails to self-test, see
Troubleshooting on page 16.

ALARM SMART SILENCE™

DANGER: If your FireAngel smoke alarm
emits the full alarm signal and you are not
testing the unit, the smoke alarm is warning
you of a potentially dangerous situation that
requires your immediate attention. Only use
the alarm silence function after making sure
that there is no fire. Do not block the vents