Alarm Test; Alarm Smart Silence - FireAngel Thermoptek ST-620 User Manual

ALARM TEST

The alarm must be properly attached to the
base plate before it can be tested.
a Press the test button in the centre and
release.
b The unit will give an audible alarm
consisting of 2 cycles of 3 loud beeps,
then stop automatically.
c The red LED on your alarm will flash
rapidly during the audible signal.
8
NOTE: The test button accurately tests
the alarm's smoke sensing circuit, there is
no need to test your alarm with smoke. If
your smoke alarm fails to give an audible
test signal, please refer immediately to the
Troubleshooting section at the end of this
manual.
WARNING: As with all electronic alarm
products you should test your smoke alarm
every week.
ALARM
SMART SILENCE™
DANGER: If your smoke alarm emits the
full alarm signal and you are not testing the
unit, the smoke alarm is warning you of a
potentially dangerous situation that requires
your immediate attention. Only use the
alarm silence function after making sure that
there is no ongoing fire emergency situation.
Do not block the vents on the alarm or
disable the smoke alarm in any way, as this
will remove your protection. Smoke alarms
can sometimes react to cooking fumes or
other non emergency situations. Your smoke
alarm features "Smart Silence" technology.