Alarm Test; Alarm Smart Silence - FireAngel THERMOPTEK Wi-Safe 2 User Manual

ALARM TEST

The alarm must be properly attached to the
base plate before it can be tested.
a) Press the test button in the centre and
release.
b) The unit will give an audible alarm
consisting of 2 cycles of 3 loud beeps, then
stop automatically.
c) The red LED on the alarm will flash rapidly
during the audible signal.
10
NOTE: The test button accurately tests
the alarm's smoke sensing circuit, there is
no need to test your alarm with smoke. If
your smoke alarm fails to give an audible
test signal, please refer immediately to the
trouble shooting guide at the end of this
manual.
WARNING: You should test your smoke
alarm every month.
If your ST-632 is interlinked with other smoke
alarms, we recommend that every individual
smoke alarm is tested during the monthly test.
a) Briefly press the test button in the centre
of the smoke alarm and release.
b) The unit you are testing will give an
audible alarm consisting of 2 cycles of
3 loud beeps, then stop automatically.
The red LED on this alarm will flash rapidly
(once per second) during the audible
alarm. All interlinked alarms will give an
audible alarm consisting of 2 cycles
of 3 loud beeps, then stop automatically,
indicating the test is complete. The red
LED on all interlinked alarms will not flash
rapidly. If any alarm fails to self-test, see
Troubleshooting..
ALARM SMART
SILENCE™
DANGER: If your smoke alarm emits the
full alarm signal and you are not testing the
unit, the smoke alarm is warning you of a
potentially dangerous situation that requires
your immediate attention. Only use the