Operation; Alarm Test - FireAngel Thermoptek ST-622 User Manual

Once the smoke alarm has been fitted onto
the base plate correctly, the internal power
pack will activate The red LED on the front
of the alarm should now flash once every
40 seconds to show that it is active
4 Test Your Smoke Alarm
After fitting the alarm to the base plate, wait
for 5 seconds for the alarm to settle then
test the alarm See 'Alarm Test'

OPERATION

Normal condition
The red LED on the front should flash every
40 seconds to show that the alarm is active
Low Power Pack Condition
IMPORTANT: Your smoke alarm requires the
power pack to have sufficient capacity of
power to operate correctly
Should your smoke alarm enter a low power
pack condition, the unit will emit an audible
'chirp' once every 40 seconds When this
occurs, we recommend you replace the
alarm immediately Your smoke alarm will
continue to warn of this low power pack
condition for at least 30 days, however,
failure to change the alarm after this time
would mean your smoke alarm may have
insufficient power to alert you in a real
fire situation. When the alarm is removed
from the base plate the power pack will
automatically deactivate and the low power
warning chirp should stop, allowing you to
dispose of the alarm
8
Low Battery Warning Silence
This feature can temporarily silence the
low battery chirp for 8 hours which is
particularly useful if the warning begins
during the night This feature may be
repeated up to 10 times, but is not a
substitute for replacing the smoke alarm

ALARM TEST

The alarm must be properly attached to the
base plate before it can be tested
a Press the test button in the centre and
release