Alarm Test; Alarm Smart Silence - FireAngel Thermoptek ST-632 User Manual

ALARM TEST

The alarm must be properly attached to the
base plate before it can be tested.
a) Press the test button in the centre and
release.
b) The unit will give an audible alarm
consisting of 2 cycles of 3 loud beeps, then
stop automatically.
c) The red LED on the alarm will flash rapidly
during the audible signal.
NOTE: The test button accurately tests
the alarm's smoke sensing circuit, there is
no need to test your alarm with smoke. If
your smoke alarm fails to give an audible
test signal, please refer immediately to the
trouble shooting guide at the end of this
manual.
WARNING: You should test your smoke
alarm every month.
ALARM SMART
SILENCE™
DANGER: If your smoke alarm emits the
full alarm signal and you are not testing the
unit, the smoke alarm is warning you of a
potentially dangerous situation that requires
your immediate attention. Only use the
alarm silence function after making sure that
there is no ongoing fire emergency situation.
Do not block the vents on the alarm or
disable the smoke alarm in any way, as this
will remove your protection. Smoke alarms
can sometimes react to cooking fumes or
other non emergency situations. Your smoke
alarm features "Smart Silence" technology.
In the event of a known false alarm your
smoke alarm can be temporarily silenced by
pressing the central test button. Your alarm
will automatically return to full sensitivity
within 10 minutes.
9