Air Tube Removal And Replacement - Travis Industries 1750 Fireplace Insert Owner's Manual

Baffle Removal & Replacement
1 Push the front firebricks up and feed them forward, guiding them out the door. Repeat for the
rear firebricks.
Front Baffle Support
Front Air Tube
2 The baffle supports rest on support tabs.
3 The bypass support and damper are difficult to remove and should only be removed if necessary.
Remove the rear secondary air tube (see the following section for instructions). Slide the bypass
support forward until the bypass rod can be disconnected from the bypass damper. Slide the
damper forward and remove. The bypass support is removed by sliding it forward and rotating it
downwards (the bypass holder fits very snug inside the firebox and is very heavy, making it
difficult to remove). The bypass gasket rests on the side and rear air channels. Try not to
damage it when removing the bypass holder.
Air Tube Removal & Replacement
Air Tube
© Travis Industries
Maintaining Your Appliance
Baffle Firebrick
Support Tabs
Air Tube Collar
100-01234
Bypass Rod (& Yoke)
Center Baffle Support
Remove the left pin on the air tube collar
a
Roll Pin
Slide the air tube to the left, swing it
b
down and remove from the firebox.
Bypass Damper
Bypass Support
Bypass Gasket
4141211
31