Table of Contents
Advertisement
Altera Corporation
July 2010
Read/Write Data
To read from and write to the flash memory, follow these steps:
Figure 3–5. Control Panel Flash Memory Tab
1.
Click Erase Block to perform a block erase of the flash memory. The
Address column indicates the hex address of the flash memory. The
values inside the 0-3, 4-7, 8-B, and C-F columns are the flash
memory contents in hex words format.
2.
To write a 32-bit word to the flash memory, click the desired
location, enter the desired value in hex format, and press Enter.
Using the Control Panel
Cyclone III FPGA Starter Kit User Guide
3–7
Advertisement
Table of Contents
