Waldorf Q Keyboard User Manual page 41

Output
Output sets the audio output of the selected Instrument. The Instruments 1...4 can only be routed to
the physical outputs, the Instruments 5...16 can also be routed to the effect busses of the Instruments
1...4.
• Main Out means that the selected Instrument plays over the Main Out
jacks.
Out
• Sub Out1 means that the selected Instrument plays over the Sub Out 1
• Sub Out2 means that the selected Instrument plays over the Sub Out 2
• FX1...FX4 (only available on Instruments 5...16) means that the selected Instrument is
routed to the respective effect bus of Instrument 1...4 and therefore also plays back over
the same physical output.
• aux means that the selected instrument is routed to the internal audio bus. So you can use
this Instrument to feed the vocoder or the 5FX. For more information refer to the chapter
"Effects" on page 104 and 110.
The Instruments 1...4 define the effects that are used in the selected Multi. All other Instruments
are played back without effects unless you route them to one of the effect busses FX1...FX4. If
you do so, these particular Instruments automatically use the same physical outputs that are set
up in the respective Instrument 1...4.
If you have choose aux for an instrument you don´t hear its audio signal on the physical
outputs.
Rx. Status
Status sets the send and receive status of the selected Instrument. This means whether the Instrument
can be played over the internal keyboard, by MIDI or both.
• off means that the selected Instrument is disabled.
• Local means that the selected Instrument can only be played by the internal keyboard
(only Q Keyboard)
• Midi means that the selected Instrument can only be played by MIDI.
• Loc.+Midi means that the selected Instrument can be played by the internal keyboard and
by MIDI (only Q Keyboard).
If all Instruments were set to off or Midi, the Q Keyboard wouldn't send out any MIDI note
messages from the internal keyboard. To prevent this, the Q automatically sends out MIDI note
messages on the Global channel.
Reasonably the Status-Parameter of the Q Rack doesn't include Local and Loc.+Midi as it
doesn't have a keyboard.
Main Out, Sub Out1, Sub Out2, FX1, FX2, FX3, FX4, Aux
Output
Main Out
Rx.Stat. !Tx.Stat. 1
Midi ! Direct
Off / Midi; only Q Keyboard: Local / Loc.+Midi
41
Multi Mode – Instrument settings
and the Digital
jacks.
jacks.
Waldorf Q User's Manual