Waldorf Q Keyboard User Manual page 27

Pattern
Pattern
Step 1-8
Sound
Sound
Select
Bank A
Multi
Multi
1
To the left of the ten number buttons, you can see the Pattern / Sound / Multi Button
button is used to set the program type that is switched by the number buttons.
Entering a two-digit number will select the corresponding program within the current bank.
Here are three examples:
• Entering 01 will call up Program number 001 in the current bank.
• Entering 99 will call up Program number 099 in the current bank.
• Entering 00 will call up Program number 100 in the current bank.
To select a Program with the Number Buttons :
1. Make sure that the Play LED is lit. If not, press Play
2. If you are in Single Mode (Multimode LED is off), press one of the Instrument buttons Inst.
1...Inst. 4
button lights up and the display content will change to show the current Sound for this
Instrument.
3. Press the Pattern / Sound / Multi Button
to select lights up.
4. Enter a two-digit number with the number buttons.
5. The display shows the Program number in the top right corner and the name of the
selected Program (name may be different depending on the factory set in your Q).
Single Mode:
Multi Mode:
Drum Maps are located at number 01 to 20 of bank D. You can´t select higher a program
number for this program type.
Step 9-16 Step 17-24 Step 25-32
Bank B Bank C Bank D
2 3 4
Picture 6: Number Buttons Q Keyboard
to select an Instrument that holds the Sound or Pattern. The LED above the
Inst:1 Sound:A001
Zeitlos
Inst:1 Multi:A001
Abfahrt
27
Basic Operation – Selecting Programs
5 6 7
.
until the LED of the Program type you want
T
T
Pause
Hold
8 9 0
. This
Waldorf Q User's Manual