Waldorf Q Keyboard User Manual page 143

Footsw2 Mode
Determines the way Switch Pedal 2
details.
Footsw2 Ctrl.
Sets the controller that is used for Switch Pedal 2
Input Gain
Sensitivity of the Stereo External In
signal as follows:
Input Gain Gain
Setting
1 -8dB
2 0dB
3 +10dB
4 +29dB
It is not recommended to connect a microphone or guitar directly to the Q. Low signal level
instruments should be amplified by a special pre-amplifier before they are routed into the Q's
External In.
Mix In to
This parameter allows you to send an external audio signal directly into the Q's effect section without
the need of a note trigger.
• No external audio signal will be routed through the Q with Off being selected
• Aux will route the external audio signal to the internal audio bus. So you can use this
signal to feed the vocoder or the 5FX. For more information refer to the chapter "Effects" on
page 104 and 110.
• Inst.1 FX...Inst.4 FX will route an external signal into the effect sections of instruments
1...4 and to the corresponding audio output.
• Main Out will route an external signal directly to the Q's Main Out or the Digital Out.
• Sub1 out will route an external signal directly to the Q's Sub Out 1.
• Sub2 out will route an external signal directly to the Q's Sub Out 2.
Footsw2 Mode/Ctrl.
switch Cl| Sustain
Off / switch Cl / toggle Cl / switch Op / toggle Op
is evaluated by the Q. Please read "Footsw1 Mode" for
Sustain / Sostenuto / Control W...Z / Foot Ctrl.
1...4
Input Gain
2
. The different Input Gain settings attenuate or amplify the input
max. Input Remarks
Level
+14dBm For very high level signals.
+6dBm Studio level signals. This is the recommended setting.
-4dBm Line level signals.
-23dBm Low level signals like microphone, guitar etc.
Table 16: Input Gain Settings
Off, Aux, Inst.1...4 FX, Main Out, Sub1 out, Sub2 out
Mix In to!Mix Level
Inst.1 FX!
143
Global Parameters – Global Menu
. Please read "Footsw1 Ctrl." for details.
082
Waldorf Q User's Manual