Waldorf Q Keyboard User Manual page 142

Global Parameters – Global Menu
The various curves are identical to the ones shown under "On Velocity Curve".
For a standard keyboard aftertouch response, you should set Pressure Curve to linear or exp
1. Other curves might be applicable under special circumstances only.
Footsw1 Mode
Determines the way Switch Pedal 1
• Off means that the Switch Pedal is deactivated.
• switch Cl is for a Switch Pedal that is closed when pressed and open when not pressed.
The Q then generates a Control value of 127 when the Switch Pedal is pressed and a
value of 0 when the Switch Pedal is released.
• toggle Cl is for a Switch Pedal that is closed when pressed and open when not pressed.
The Q then generates a Control value of 127 on the first press and a value of 0 on the next
press and so on.
• switch Op is for a Switch Pedal that is open when pressed and closed when not pressed.
The Q then generates a Control value of 127 when the Switch Pedal is pressed and a
value of 0 when the Switch Pedal is released.
• toggle Cl is for a Switch Pedal that is open when pressed and closed when not pressed.
The Q then generates a Control value of 127 on the first press and a value of 0 on the next
press and so on.
Footsw1 Ctrl.
Sets the controller that is used for Switch Pedal 1
• Sustain sends the Sustain controller (controller #64) with a value of 127 to the internal
tone generation and over MIDI Out. This forces the Q envelopes to stay in their "Key
Pressed" phases until the Sustain controller is set to 0 again.
• Sostenuto sends the Sostenuto controller (controller #66) with a value of 127 to the
internal tone generation and over MIDI Out. This forces the Q envelopes of all active
voices to stay in their "Key Pressed" phases until the Sostenuto controller is set to 0 again.
Voices that are triggered after Sostenuto was set to 127, aren't affected. If they are
released, they proceed with their release phase as usual.
• Control W...Z send the respective controller number to the internal tone generation and
over MIDI Out. These controllers can be used to change any Sound parameter that is
accessible in the Standard Modulation Matrix.
• Foot Contr. send the Foot controller (Controller #4) to the internal tone generation and
over MIDI Out. This controller can be used to change any Sound parameter that is
accessible in the Standard Modulation Matrix.
Waldorf Q User's Manual
Footsw1 Mode/Ctrl.
switch Cl| Sustain
Off / switch Cl / toggle Cl / switch Op / toggle Op
is evaluated by the Q.
Sustain / Sostenuto / Control W...Z / Foot Ctrl.
142
.