Waldorf Q Keyboard User Manual page 145

Pedal/CV1 Gain
Sets the maximum gain for Control Pedal/CV 1 that is used when the pedal is at its maximum
position. To find out which value is suited for the Control Pedal/CV you want to use, do the following:
☞
To adjust Pedal/CV 1 Gain:
1. Perform the steps under Pedal/CV1 Offset.
2. Set the Matrix slot Source to MAXIMUM and adjust Amount so that you can just hear the
sound with a very high pitch.
3. Move the Pedal to its maximum position or make sure that the CV is at its maximum
voltage.
4. Adjust Pedal/CV 1 Gain until the pitch is the same no matter if you set Source to
MAXIMUM or Control W.
Pedal/CV1 Curve
Sets the curve that is used for Control Pedal/CV 1. It changes the behaviour of the internal tone
generation and the outgoing MIDI messages. It doesn't affect incoming MIDI messages.
Depending on the Control Pedal/CV you use, different values might apply. Please try to find out
the best setting yourself.
Pedal/CV1 Ctrl.
Sets the controller that is used for Control Pedal/CV 1. The respective controller is sent to the internal
tone generation and over MIDI.
The controller numbers for the various settings are:
Setting
Volume
F1 Cutoff
F2 Cutoff
Control W...Z
Pedal/CV2 Offset
Sets the initial gain for Control Pedal/CV 2 that is used when the pedal is at its minimum position.
Please read "Pedal/CV1 Offset" above for further information.
0...127
Pedal/CV1 Gain
127
0...127
Pedal/CV1 Curve
127
Off / Volume / Control W...Z / F1 Cutoff / F2 Cutoff
Pedal/CV1 Ctrl.
Volume
Number
7
69
80
the respective controller number is
sent
Table 17: Pedal/CV controller numbers
-64...+63
Pedal/CV2 Offset
+00
145
Global Parameters – Global Menu
Waldorf Q User's Manual